MakerGram last edited by MakerGram
HackCamp is a Hackathon aims to Create anything that can imagine with code, electronics, 3D models, and more, it's organized by the HackClub.
We Team MakerGram is here at the event for providing hardware support and mentorship. We have a wide verity of hardware components and development boards to make your process easier!
Come to our desk and grab it!
You can post your queries under this thread.
Request hardware by filling the form: https://forms.gle/VLr6wputD6GXs9nx6
NB: All hardware should be returned right after the event with the same condition while it was on the collection stage.
MakerGram last edited by
Single Board Computers
swalahamani last edited by
SoftSkills/Techniques that can be used through out this hackathon and even after:
Personal goal setting: Planning to live your life your way
The Ladder of Inference
Root Cause Analysis
@Ggreeshma-stani Nailed the PCB in terms of the schematic. But you got it a little bad on the layout side. There are some thumb rules while designing a layout of PCB.
Always place the oscillator and it's capacitors(C1, C2) near to the IC. If you have a doubt on this try checking the Arduino boards or any other boards. you will find an SMD chip crystal alongside of the Arduino XTAL pins. If you ask the reason for this that's simple, to avoid noise creeping in. Crystals provide the clock to the entire digital logic inside the IC. So, there should not be any noise in it. If noise is there, obviously you'll have timing issues.
The bypass caps on the voltage regulator must be placed close to the regulator's input and output pins. The reason for this is also pretty simple, bypass caps will filter out noise coming from the power supply and few other reasons too. So, try placing these bypass caps as close as possible to IC.
Apart from these points, the PCB looked good. Great work. Remember that this message is not to discourage you but just to give a suggestion so that you'll improve it in the next design.
Calling All Innovators - IgniteX Accelerator
Do you have a solution that can reduce the severity of the coronavirus outbreak, but need help commercializing and rapidly deploying? The Black & Veatch COVID-19 Response Accelerator is designed for growing companies looking to scale emerging solutions to save lives, help communities cope, and protect the economy.
Apply here https://www.bvignite.com/
@salmanfaris the pressure range that we have to measure is between 5-10 cmH20 (ie almost 0.07 - 0.0.14 psi)
Startup India - Challange
The Challenge is open to all the Startups, Companies, Innovators etc. whose innovation can plug the gap between the demand and supply of essential medical items to fight the Covid-19 outbreak as well as an innovative tech for applications such as motion tracking, geofencing, fake news detection, etc.
Powered by Startup India
Apply before Wednesday, 15th April
Submit Solutions to combat Covid19 here -https://www.startupindia.gov.in/content/sih/en/ams-application/challenge.html?applicationId=5e79126ee4b055bfaea9ef66